Midas PRO1 Owner's Manual page 99

Automation
Managing the scenes
Up to three scenes in the cue list will be highlighted to indicate your position in the
show, as follows:
• LAST (red) — the scene immediately before the most recently loaded one.
• NOW (yellow) — the most recently loaded scene.
• NEXT (green) — the next available 'non-empty' scene.
The automation section in the output bay (see "PRO1 control surface" on page 18)
supports the Automation screen by providing controls for scene navigation, selection
and management. The jogwheel is a unique automation controls, whereas the other
buttons are replicated on the GUI.
>> To recall a scene
Important:
When recalling a new scene, make sure monitor output levels are low, as the
new scene's settings may produce higher audio output levels than the one it is
replacing. Also, recalling a scene clears any unsaved adjustments made to the
previous scene.
Press last, now or next as desired.
>> To create a new scene using the current settings
1
Do one of the following:
• In the automation section, press store.
• In Automation screen on the GUI, click STORE SCENE.
2
In the Store Scene window, type in the scene
name if necessary.
3
In the Notes panel, type in any scene notes as
desired.
4
Do one of the following:
• Click "Insert before scene" to put the new
scene in between the one currently highlighted
in yellow and the scene immediately before it.
• Click "Store to empty scene" to put the new
scene in the one currently highlighted in yellow, provided it is empty.
PRO1 Live Audio System
Operator Manual
81