1. LAMP HOUSE WITH 2.5 KW LAMP
Purpose of the Lamp House with 2.5 kW lamp
The Lamp House with 2.5 kW lamp is exclusively designed for the Barco HDX series and can thus not be used on any other equip-
ment.
Overview
•
Introduction
•
Safety
1.1
Introduction
Order info & content of the kit
When ordering the Lamp House with 2.5 kW lamp for HDX series, refer to article number R9864130.
The table below gives an overview of the content of the kit.
Article number
R5905109
R856950
Image 1-1
1.2
Safety
Safety instructions
Read and heed the following warnings and cautions.
W
ARNING
W
ARNING
down cycle to finish after switching the projector to standby (the sound of the fans comes to a very low level)
and wait for 15 more minutes before starting any of the procedures below.
W
ARNING
jector. Failure to do so can cause serious injury or death.
R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011
Description
This installation manual
Lamp House with 2.5 kW lamp
Image 1-2
:
The procedures below may only be performed by Barco trained and qualified technicians.
:
The projector must be cooled down before removing any of the projector covers: wait for the cool
:
Unplug the mains power supply cord in order to completely cut off the power supply to the pro-
1. Lamp House with 2.5 kW lamp
Quantity
1
1
Image
image 1-1
image 1-2
3