Advertisement
ASSEMBLY
27. Install Front Seed Shaft Coupler and tighten Rear
Seed Box Feed Roll Coupler Assembly Set Screws
against the Seed Shaft and tighten Jam Nuts against
Feed Roll Coupler.
28. Tighten the Transmission #40 Drive Chain Idler
Sprocket Clevis Drawbolt Locknut to apply tension to
the Drive Chain and secure by tightening the Axle
Bolt. See "Transmission (Before 01/2020)" on
Page 5-7.
Bolt,5/16-18
x 1-1/4
2-34
Bearing Carrier
RH Seed Shaft
Nut,1-8
Figure 2-58: Rear Box RH End Assembly
29. 8FT and 10FT Seeders: Install RH and LH Light
Brackets.
12FT Seeders: Install Turnbuckles to Double Box
RH Support, Double Box Center Bracket and LH
Double Box Mounting Plate.
30. Connect Acre Meter and Warning Lamps.
RH Double Box Support
Bolt,5/16-18 x 1
Flat Washer,5/16
Lock Washer,5/16
Nut,5/16-18
Lock Washer,
5/16
Nut,5/16-18
SL2 OpRearBoxSeedAdjuster
Adjusting
Screw
Bearing
Flangette
Seed Rate
Adjusting Nut
Locknut,1/2-13
9K998-0522
Advertisement
