Advertisement
ASSEMBLY
Console w/Clutch Control
Tractor Installation - Optional
1. Mount Angle Bracket onto Tractor where convenient
for the operator. See Figure 2-41.
2. Attach Straight Bracket to Angle Bracket with 1/2-13
x 1-1/2 Bolt and Flanged Ny-Lok Nut.
3. Attach the Console to the Straight Bracket with
1/4-20 x 1 Bolt, Flat Washers and Locknut.
Bolt,1/4-20 X 1
Straight Bracket
Washer,Flat 1/4
Locknut,1/4-20
2-26
SSP16 Monitor
Console
Figure 2-41: Console w/Clutch Control Tractor Installation
4. Plug Console 3-Pin Power Cord into the Tractor
Convenience Outlet and 9-Pin Cord into the Seeder
Harness.
5. Check clutch operation: Clutch will disengage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch on and off. The seed shaft will
stop rotating when switch is turned to "NO SEED"
position. See "Console w/Clutch Control -
Optional" on Page 3-8.
Washer,Flat 1/4
Bolt,1/2-13 X 1-1/2
Locknut,
Flange 1/2-13
3-Pin Power
Connector
9-Pin Amp
Connector
Angle Bracket
9K998-0522
Advertisement
