Advertisement
ASSEMBLY
Console w/Clutch Control
Installation - Optional
1. If equipped with Clutch Switch Bar, remove from
Tractor and remove Clutch Harness from Seeder.
2. Mount Seeder Console with Clutch Control on
Tractor.
3. Route Console Harness with 9-Pin Connector to the
Seeder Harness.
4. Attach 3-Pin Power Plug to Tractor.
5. Secure Console Harness with tie wraps.
Seeder Console
with Clutch Control
Clutch included
with Seeder
2-24
Power Plug
9-Pin
Connector
Seeder
Harness
Left Front Seed
Seed Shaft
Shaft Sensor
Sensor
Figure 2-38: Console w/Clutch Control Electrical Schematic
6. Route Seeder Harness along Frame of Seeder.
Ensure plug labeled Electric Clutch Power is on the
left side.
7. On left side connect plug labeled "Electric Clutch
Power" to the Electric Clutch Lead. See Figure 2-38.
8. Connect plug labeled "Left Front Seed Shaft Sensor"
to the left front Seed Shaft Sensor. Seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
9. Repeat for the right side.
10. Secure all Harnesses with tie wraps.
3-Pin
Labled
Right Front Seed
Shaft Sensor
Labled
Labled
Left Rear Seed
Shaft Sensor
3-Pin Tower
Cavity Plug
Seed Shaft
Sensor
3-Pin
Tower
Labled
Right Rear Seed
Shaft Sensor
Labled
Electric Clutch
Power
Cavity
Plug
9K998-0522
Advertisement
