Advertisement
ASSEMBLY
3-PT Seeder Assembly
When shipped, seeder comes assembled except for
Lights and 3-PT Hitch.
1. Support Seeder Assembly with a hoist or by similar
means capable of supporting its weight without
tipping.
2. Center 3-PT Hitch Assembly in relationship with the
Seed Box Center Bracket. Attach 3-PT Hitch to
Seeder Frame Tube with 5/8-11 U-Bolts, Lock
Washers and Locknuts. See Figure 2-4.
3. Install Manual Holder to 3-PT Hitch with Hose
Clamps.
4. 8FT and 10FT Seeders, install SMV Support to Seed
Box Center Bracket with 3/8-16 x 1-1/2 Bolts, Flat
Washers, Lock Washers, and Locknuts. See
Figure 2-1.
SMV Support
Seed Box
Center
Bracket
Nut,
3/8-16
Lock
Washer,3/8
Flat Washer,3/8
Figure 2-1: SMV Support
2-2
SMV
Bolt,
3/8-16 x 1-1/2
Do not disengage pin unless seeder is fully
attached to a tractor. Seeder may be rear-heavy
and tip backward on frame.
5. Be sure Parking Pin is locking Rear Roller down and
raise the Seeder. See Figure 2-2.
Klik Pin
Parking Pin
Figure 2-2: Parking Pin Engaged
6. On the right side of the Seeder Frame, in a similar
position as the Parking Pin, remove the 5/8-11
Shipping Bolt that also locks the Rear Roller down.
See Figure 2-3.
Flat Washer,5/8
Locknut,5/8-11
Figure 2-3: Shipping Bolt
CAUTION
Engaged
Bolt,5/8-11
9K998-0522
Advertisement
