Advertisement
ASSEMBLY
Tire and Wheel Installation
Use a torque wrench to assure proper torque.
Insufficient torque can cause stud breakage and
damage the wheel pilots. Over torque can stress
the Bolts and strip the threads.
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward from Hub and Spindle.
IMPORTANT
Torque will drop after the first 10 hours of operation.
Check the Wheel Bolts for proper torque after this
interval and re-tighten them.
• 8FT Seeder uses 9.5L x 15, 8Ply Implement Rib
Rating Tires and should be inflated to 44 PSI.
• 10FT and 12FT Seeder uses 11L x 15, 12Ply
Implement Rib Rating Tires and should be inflated to
52 PSI.
• Install a Tire and Wheel Assembly onto each Hub
with 1/2-20 x 1 Wheel Bolts and tighten Wheel Bolts
to 50 Ft-Lbs using the sequence in Fig and 2-8.
Then tighten to a full torque of 80-85 Ft-Lbs.
Wheel Arm
2-6
WARNING
Bolt,
1/2-13 x 3
Spindle
Figure 2-9: Tire and Wheel Installation
3
Figure 2-8: Tightening Sequence
Locknut,1/2-13
Hub
1
6
5
2
6 BOLT
Tire and Wheel
Assembly
Wheel Bolt,
1/2-20 x 1
4
9K998-0522
Advertisement
