Advertisement
outside of the Seed Box. To get the Sensor Connector
outside the Seed Box, feed the terminals through the
Cord Grip. Install the terminals into the 3-Pin Shroud
labeled "A", "B" and "C" as follows "A" White, "B"
Black, "C" Green. See Figure 2-28. Inside the Seed
Box, add enough slack to the Bin Level Sensor Cord
to allow for future adjustments of the Sensor. Secure
the Bin Level Cord by tightening the Cord Grip
Compression Nut. Connect both Bin Level Sensors to
the Seeder Harness.
Shroud Pin ID
Terminal
3-Pin Shroud
Seal
Figure 2-28: Bin Level Sensor Wire Detail
Smart Shaft
Sensor
Seed Shaft, 11/16 Hex
Magnet Wheel Assembly
A
Smart Shaft
Sensor
A
Magnet
Collar
3/8 Sq Shaft
Magnet
9K998-0522
White Wire
Black Wire
Green Wire
A
Sensor Mount
A
Figure 2-29: Front Seed Box Smart Shaft Sensor Detail
Sensor Mount,
4.25 Spacing
Smart Shaft Sensor
Seed Shaft,
3/8 Square
Figure 2-30: Rear Seed Box Smart Shaft Sensor Detail
8. Connect the 240" Extensions Harness to the Seeder
Harness. Route the 240" Extension Harness along
the Seeder Frame and down the Drawbar/3-PT Hitch
to the Tractor.
9. Install Brillion Elite Mini Monitor on Tractor. See
"Brillion Elite Mini Monitor Tractor Installation -
Optional" on Page 2-23.
10. If not already installed, install Smart Clutch Relay into
Elite Mini Tractor Harness 3-Pin Connectors.
11. Connect the Elite Mini Tractor Harness 14-Pin
Connector to Brillion Elite Mini Monitor, 3-Pin Power
Plug to 12 Volt Tractor Convenience Outlet and 6-Pin
Connector to the 240" Extension Harness. 4-Pin
Connector is not used at this time.
12. Bundle and secure all Harnesses along the Seeder
Frame and Drawbar/3-PT Hitch with Tie Wraps.
13. Program Bin Level Sensors and Smart Shaft
Sensors if not already pre-programmed. See
"Brillion Elite Mini Monitor" on Page 4-1.
SECTION A-A
Sensor
Mount
Smart Shaft
Sensor
1/8" Max
Sensor Mount,
4.25 Spacing
1/8" Max
ASSEMBLY
Magnet Wheel
Assembly
SECTION A-A
Magnet Collar
3/8 Sq Shaft
Magnet
2-19
Advertisement
