MACHINE OPERATIONS AND CONTROLS
4. Loosen mounting bolt (4) of the camera and adjust mount-
ing angle (A) of the camera so that the center line of
mounting bolt (4) is aligned with fourth-from-bottom scale
(B).
REMARK
Part of the machine is shown on the monitor screen.
5. After adjusting, tighten bolt (4).
Tightening torque: 3-5 Nm (0.3-0.5 kgm)
Rear View Mirrors
Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the
visibility and may be injured or may injure someone seriously.
3-122
WARNING
OPERATION