Table of Contents
Advertisement
Regumaq X-45
Operation
8.11.4 End of recording
Select the menu item "Remove card" and remove the card.
8.11.5 Saving of the controller settings
f
To save the controller settings on an inserted microSD
card, select the menu item "Save adjustments".
Z
When the saving process is complete, the message
"Done" appears. The controller savings are saved in a
.SET fi le on the microSD card.
8.11.6 Loading of the controller settings
f
To load the controller settings from a microSD card,
select the menu item "Load adjustments".
f
Select the desired .SET fi le.
Z
When the loading process is complete, the message
"Done" appears.
Before removing the microSD card, always select
the menu item "Remove card" to avoid data loss.
8.12 Manual mode
In the "Manual mode" menu, you can set the operating
mode of all outputs used.
You can check the function of all connected components,
such as relays, pumps etc. by switching them on
temporarily by hand here.
8.13 Blocking of the controller settings
The function "Block controller adjustments" can be used to
prevent improper modifi cation of the settings.
f
To activate the function "Block controller adjustments",
select "Yes".
Z
The controller jumps to the start screen. All settings
and access to the menu are blocked.
When "OK" is pressed, the controller asks for a
user code. The main menu is available after enter-
ing a user code.
8.14 Anti-blocking protection
The anti-lock protection is used to prevent the primary
pump from seizing up after long periods of standstill.
The pump is switched on for 5 seconds 24 hours after the
end of its last activation.
46
8.15 Replacement of the fuse
The controller is protected by a fuse (T4AH250V) (position
1
in Fig. 16 on page 25).
The fuse holder contains a spare fuse when deliv-
ered.
DANGER
Danger to life due to electric current!
There is a danger to life if live components are
touched.
!
Disconnect the product from the power supply
at all poles.
!
Check that no voltage is present.
!
Secure the product against being switching
back on again.
!
Only install the product in dry indoor areas.
NOTICE
Damage to the electrical lines and connections
due to tensile forces!
Electrical lines or connections can break if
excessive tensile forces are applied.
!
Make sure that the cables connected to the
controller are not subjected to strain.
1
Disconnect the controller from the power supply at all
poles.
2
Loosen the screw (position
and put it aside.
3
Slide the connection panel cover (position
on page 31) upwards until it audibly clicks into
place.
4
Pull the fuse holder out of the socket.
5
Replace the fuse. Only use fuses that comply with the
technical data (see par. 3.5 on page 15).
6
Close the connection panel cover.
7
Fix the bonnet by tightening the screw.
8
Restore the power supply.
2
in Fig. 24 on page 31)
1
in Fig. 24
138114082-V04.04.2022
Advertisement
Chapters
Table of Contents
