Operation; Start Screen; Main Menu; Fig. 26: Touch Control Panel - oventrop Regumaq X-45 Operating Instructions Manual

Regumaq X-45

Operation

8. Operation
You can operate the station via the touch control panel in
the upper shell.
Fig. 26: Touch control panel
Touch key " "
Touch key " "
Touch key "OK"
If no touch key is pressed for 5 minutes, the dis-
play changes to the start screen.
8.1

Start screen

In normal mode of the controller, the display is in the start
screen. The start screen displays the set hot water
temperature. If the operating function has not been
locked, anyone can select the hot water temperature in the
start menu.
You can switch to the start screen at any time by
pressing and holding the touch keys " " and " "
simultaneously.
After this change, you are in the user menu. For
extended operating options, you must log in with
the corresponding pin.
If the system has detected an error, a correspond-
ing message is displayed in place of the tempera-
ture setting.
138114082-V04.04.2022
Scrolling through the menu to
the right / Increasing the set
values
Scrolling through the menu to
the left / Decreasing the set
values
Confi rm
8.2

Main menu

1
To go from the start screen to the main menu, press
the touch key "OK".
Z
The "Status" menu appears.
Fig. 27: Main menu
The "Status" submenu is for information purpos-
es. No settings can be made here.
The number of circles displayed in the lower area
depends on the number of functions available or
activated at the time.
The available functions can be activated with the
appropriate user authorisations.
The fi lled circle of the navigation button indicates
where you are in the menu.
In the menus where you can select a function, the
icon for "Back" appears when you scroll all the
way to the right with the touch key " ". Press
"OK" to go to the higher menu level.
In menus where you can enter a numerical value,
the minimum value is indicated at the boom left
and the maximum value at the bottom right.
The large fi gure in the middle shows the current
setting.
The available setting range can be confi gured
with the corresponding user authorisations.
2
Use the touch keys " " or " " to select the desired
submenu.
3
Press the "OK" touch key to open the respective
submenu.
4
Use the touch keys " " or " " to set the desired value.
5
Confi rm your entry by pressing the "OK" touch key.
33