Table of Contents
Advertisement
Regumaq X-45
Mounting
6.2.2 Mounting
To ensure that the magnetic contact is closed cor-
rectly, the upper shell must be fi tted accurately.
f
Avoid tilting.
f
When mounting on a stud frame, make sure that in
addition to a cross brace at the height of the wall
bracket, another one is installed at the height of the
magnetic contact!
1
Pull the product out of the box.
2
Lift off the upper shell (see Fig. 12 on page 24).
Fig. 12:
Removal of the upper shell
3
Dismantle the wall bracket.
Fig. 13:
Dismantling of the wall bracket
4
Hold the wall bracket horizontally against the wall to
24
use it as a drilling template.
5
Mark two holes.
Fig. 14:
Use of the wall bracket as drilling template
6
Drill the corresponding holes (ø 8 mm) and insert the
dowels.
7
Screw the wall bracket onto the wall with two
10x60 mm screws and washers (supplied).
8
Hang the lower shell with the product assembly onto
the wall bracket.
Make sure that the bracket audibly clicks into
place. Make sure that the station is fi rmly seated
on the bracket.
9
Place the washer in the contour provided in the lower
shell.
Fig. 15:
Position of the washer
22
Position of the washer
10
Fix the lower shell with the cylinder screw with
hexagon socket (M5 x 20). Tighten the screw to the
metallic stop.
Z
Wall mounting of the fresh water station is completed.
In the next step you can start with the piping.
22
138114082-V04.04.2022
Advertisement
Chapters
Table of Contents
