Table of Contents
Advertisement
6.1
Mounting the automatic steering unit on the paver finisher
m
During operation, no work may be carried out on the automatic steering unit!
Depending on the desired sensing side on the vehicle, the sensor rod tube may have
A
to be removed and re-inserted on the other side of the vehicle!
- Pull the sensor rod tube (1) at the front of the vehicle out to the desired length and
secure with the clamping bolts (2).
Only for 14 m automatic steering unit:
A
-Push the connecting tube (3) into the sensor rod tube (1), fix with bolts and lock
nuts (4).
-Push extension (5) onto the connection tube and fix in the same way.
-Fix support wheel (6) in a suitable position using the corresponding assembly parts.
-Heed vertical alignment!
- Insert tube (7) to the required length and also fix with bolts and lock nuts (8).
- Fit the clamping piece (9) with extension arm (10) to the end of the tube.
Heed vertical alignment!
A
- If necessary, adjust the height of the support wheel at the adjustment knob (11)
until all extension tubes are horizontally in line.
- Swivel the extension arm (9) to the desired angle and secure by tightening the
bolt (12).
Use of the automatic steering unit increases the basic width of the paver finisher!
m
If the automatic steering unit is used, ensure that there are no persons or obstacles
A
in the danger area.
E 10 42
Advertisement
Table of Contents
