Table of Contents
Advertisement
E 10
Set-up and modification
1
Special notes on safety
f
Danger to personnel by inadvertent starting of the engine, travel drive, conveyor,
auger, screed or screed lifting devices.
Unless otherwise specified, work may only be performed when the engine is
at a standstill!
- To protect the paver finisher against inadvertent starting:
Move drive lever into centre position and turn preselector controller to zero, remove
ignition key and battery main switch.
- Protect lifted vehicle parts (e.g. screed or hopper) against lowering by means of
mechanical safeguards.
- Replace parts or have them replaced as stipulated.
f
When connecting or disconnecting hydraulic hoses and when working on the hydrau-
lic system, hot hydraulic fluid may spurt out at high pressure.
Switch off the engine and depressurise the hydraulic system! Protect your eyes!
- Mount all protective devices before re-commissioning the paver finisher.
- The walkway must always reach over the entire working width of the screed.
The hinged walkway plate may only be folded up under the following conditions:
- When paving next to a wall or a similar obstacle.
- During transportation on a low-bed trailer.
DANGER
Danger due to changes at the vehicle
Structural chances to the vehicle make the operating
licence null and void and can cause severe to fatal injuries!
- Only use original spare parts and approved accessories.
- After maintenance and repair work, ensure that any dis-
mantled protective and safety devices are all completely
fitted again.
- Comply with all further information in these instructions
and in the safety manual.
E 10 1
Advertisement
Table of Contents
