Table of Contents
Advertisement
Before mounting the auger brace, the required auger height should already have
A
been set on the basic auger!
Note the section "Height adjustment for large operating widths / with brace"!
- Mount the left/right guide plates (1) on the vehicle frame shackles with the relevant
assembly parts (2).
The guide plates must be mounted on the front side of the shackles.
A
- Slide the support shackle (3) over the guide plate and secure in the groove with a
pin (4) and split pin (5).
- Slide the lower support shackle (3) over the attaching point of the material shaft and
secure with a pin (6) and split pin (7).
The brace bracket (8) is located directly on the drive unit.
A
The rear brace bracket is used for the first brace set!
A
For larger working widths, the second brace set is mounted on the front brace bracket.
- Insert the fulcrum bracket (10) into the brace bracket (8) and secure with the retain-
ing pin (11).
- Secure the retaining pins (11) with a split pin (12).
The first brace set must be set in the rear bore. If the operating width necessitates a
A
second brace, the front bore must be used!
- Mount the slewing bracket (14) at the brace shaft (13) with retaining pins (15).
- Secure the retaining pins (15) with a split pin (16).
- Mount the braces (17) on the fulcrum bracket (10) with the assembly parts (18).
The braces must be mounted on the outer side of the fulcrum bracket (10)!
A
- Remove the spring cotter pin (19) and retaining pin (20), pull out the adjustment rod
(21) until the brace can be mounted on the slewing bracket (14) together with the
corresponding assembly parts (22).
- Secure the adjustment rod (21) in an appropriate bore with a retaining pin (20) and
spring cotter pin (19).
- Mount the vertical brace (23) in the same way.
- In this case, secure the vertical brace at the outer auger bearing (24) and the low-
er support bore (25).
At the support (3) mounting point, the brace must be secured at the rear side in
A
each case!
E 10 20
Advertisement
Table of Contents
