Table of Contents
Advertisement
Conveyor limit switches -
conventional version
The mechanical conveyor limit switch-
es (1) control the material flow on the
relevant half of the conveyor. The con-
veyors should stop when the material
has roughly reached the area below
the auger tube.
This requires that the auger height has
A
been adjusted correctly (see chapter E).
- To set the deactivation point, release
the two mounting screws (2) and set
the switch to the required height.
- After adjusting, retighten all mounting
parts properly.
D 30 28
1
2
Advertisement
Table of Contents
