Table of Contents
Advertisement
External starting (starting aid)
The engine can be started with the help of an external power source if the batteries
A
are empty and the starter no longer turns.
Suitable power sources are:
- Other vehicles with a 24V system
- Additional 24V battery
- Start device that is suitable for external starting (24 V/90 A).
m
Standard chargers or quick chargers cannot be used for external starting.
To externally start the engine:
- Set the drive lever (1) to the centre position and the engine speed adjuster (2)
to minimum.
- Insert the ignition key (3) in position "0" to switch on the ignition.
m
The starting aid cable must be connect-
ed to 24 V.
- First connect the positive terminal (1)
of the starting aid battery to the posi-
tive terminal (2) of the vehicle battery.
- Then connect the negative terminal
(3) of the starting aid battery to the
ground of the discharged vehicle, e.g.
to the engine block or to a bolt (4) on
the vehicle frame.
f
Do not connect the starting aid cable to
the negative terminal of the discharged
battery! Danger of explosion!
m
Lay the starting aid cable so that it can
be disconnected once the engine is running.
Starting is not possible when the "Start inhibit" (4) or drive mode (5) indicator lamps
A
indicate that an emergency stop button (6) / (7) on the remote control has been
pressed, or the auger function (8) or conveyor function (9) are switched to "AUTO" or
"MANUAL" operating mode.
NOTE
D 40 8
Caution! Possible subsequent damage!
- No additional consumers (light, heater, etc.) may be
switched on when starting.
- Do not switch the consumers on until the engine has
reached a speed of >1000 revs.
2
1
3
4
Advertisement
Table of Contents
