Table of Contents
Advertisement
3.1
Mounting extension parts
Mounting the material shaft and auger extension
3
- Secure the additional material shaft (1) to the basic unit or the adjacent material
shaft with the relevant assembly parts (2) (bolts, washers, nuts).
- Dismantle the assembly parts (3) of the adjacent auger blade, remove plug (4).
- Guide the auger shaft extension into the auger shaft.
- Reinstall the previously removed assembly parts (3) and simultaneously tighten the
auger shaft bolts.
- Insert the plug (4) at the end of the auger.
Depending on the operating width, the outer auger bearing and/or auger end bearing
A
must be installed:
4
2
1
E 10 7
Advertisement
Table of Contents
