Cisco AS5350XM Installation Manual page 67

Appendix A Replacing Memory Components
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
Remove all interface cables from the rear panel of the universal gateway.
Step 2
Attach an ESD-preventive wrist strap.
Step 3
Step 4 Remove the chassis cover. (See the instructions in the
page A-1.)
Step 5 Use Figure A-3
Step 6 Pull the socket latches away from the DIMM, and then pull the DIMM out of the socket. (See
Figure
To prevent damage, do not press on the center of the DIMM. Handle the DIMM carefully.
Caution
Figure A-4
Position the new DIMM so that the polarization notch is located at the right end of the DIMM socket.
Step 7
OL-6417-02
to locate the DIMM you are replacing.
A-4.) The latches hold the DIMM tightly, so be careful not to break the socket.
Removing and Replacing the DIMM
"Removing the Chassis Cover" section on
Cisco AS5350XM Universal Gateway Chassis Installation Guide
Replacing DIMMs
A-7