Connecting To The Network; Connecting To An Ethernet Network - Cisco AS5350XM Installation Manual

Connecting to the Network

Figure 3-5

Connecting to the Network

This section describes how to connect the Cisco AS5350XM universal gateway to your network. The
cables required to connect the universal gateway to a network are not provided. For ordering information,
contact customer service. See the
Appendix C, "Cabling Specifications,"
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
If the universal gateway is configured with fewer than three DFCs, make sure that a blank slot cover is
Caution
installed over each open slot to ensure proper airflow.
The Cisco AS5350XM universal gateway arrives with all carrier cards and DFCs already installed,
Note
unless you order a card separately as a spare. See the Cisco AS5350XM and Cisco AS5400XM Universal
Gateways Card Installation Guide for card installation instructions. This document is available on
Cisco.com. (See the

Connecting to an Ethernet Network

Connect an Cisco AS5350XM universal gateway Gigabit Ethernet port to an Ethernet hub using a
straight-through, RJ-45-to-RJ-45 Ethernet cable. (See
Cisco AS5350XM Universal Gateway Chassis Installation Guide
3-6
Cisco AS5350XM Universal Gateway Ground Lug Attachment
Ground lug
attachment
"Obtaining Documentation" section on page
Chapter 3
"Obtaining Technical Assistance" section on page
for cable and port pinouts.
Figure
Installing the Cisco AS5350XM Universal Gateway
xvii, or see
xiv.)
3-6.)
OL-6417-02