Replacing The Compact Flash - Cisco AS5350XM Installation Manual

Replacing the Compact Flash

Replacing the Compact Flash
To replace the compact flash, follow these steps:
Turn the power switch off and disconnect site power.
Step 1
For DC-powered units, note the following warnings:
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning Before connecting or disconnecting ground or power wires to the chassis, ensure that power is
removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel
board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch
handle of the circuit breaker in the OFF position. Statement 140
Before opening the unit, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
Remove all interface cables from the DFCs.
Step 2
Attach an ESD-preventive wrist strap.
Step 3
Remove the chassis cover. (See the instructions in the
Step 4
page
Locate the compact flash on the system board. (See
Step 5
Cisco AS5350XM Universal Gateway Chassis Installation Guide
A-4
A-1.)
Appendix A Replacing Memory Components
"Removing the Chassis Cover" section on
Figure A-3.)
OL-6417-02