3.5.8.2
LCD (Line Crossing Detection)
Line Crossing Detection function detects people, vehicle or other objects which cross a pre-defined virtual line, and some
certain actions can be taken when the alarm is triggered.
Channel: Select the channel you want to configure
•
Switch: Enable or disable the LCD function
•
Buzzer: Disable or to active the buzzer to emit an alarm tone in 10, 20, 40 or 60 seconds when the detection is
•
triggered
Sensitive: The sensitivity level is from 1 to 4. Higher sensitivity will be easier to trigger the detection.
•
Scene: Scene setting includes Indoor and Outdoor. Please choose the scene to match with the place your
•
camera installed.
IVA Lines: Enable or disable the IVA Lines.
•
Post Recording: You can set how long after an event occurs that the HVR will continue to record.
•
Latch Time: To configure the external alarm time when the detection is triggered.
•
Alarm Out: If your HVR support to connect to external alarm device, you can set to emit an alarm tone.
•
Show Message: A letter "S" will be displayed on the screen when the LCD function is triggered.
•
Send Email: If an alarm is triggered, an Email will be sent to your preset email account.
•
Full Screen: When the detection is triggered, the channel will be enlarged into full screen.
•
Record Channel: to select the channel(s) you want to record when a detection is triggered.
•
Area: Click [Setup] to draw a virtual line in the camera picture.
•
DS1097-010
37