Email Schedule; Ftp - urmet domus 5M-Lite HVR Series User Manual/Instructions

3.8.3.2

Email Schedule

This configuration page can be used, as seen in the other cases, to select on which times and days of the week the HVR
must send an email in case of a given event.
Channel: this is used to select the channel to be configured.
•
Motion: use this option to define the times at which to enable for sending Email in case of automatic motion
•
detection.
IO: use this option to define the times at which to enable for sending Email in case of sensor alarm detection.
•
Event: select to define the times at which the system will send an email in case of a system event.
•
In-Analisys: use this option to define the times at which to enable sending in case of intelligent video analysis
•
detection.
PIR: use this option to define the times at which to enable sending in case of automatic PIR detection.
•
Default: Restore the Schedule default settings.
•
Copy: this is used to copy the current channel settings on another or on all other channels.
•
.
At the end, click on [Save] to make the configuration permanent.
Alternatively, click on the Default button to use the system default parameters.
NOTE:
the green bar refers to the motion alarm times, the red bar to the system event enabling times.
3.8.4

FTP

The last available item in the Network section concerns the configuration parameters to access a FTP server on which to
load the images and the recordings acquired following an alarm detected by the HVR. The options are shown under the
following figure:
3.8.4.1 FTP
This menu allows you to enable FTP function to view and load captured snapshots from HVR to your storage device over
FTP.
DS1097-010 62