Table of Contents
Advertisement
Area: Click [Setup] to draw a virtual region in the camera picture.
•
Choose one of the Rule Number. It is the number of FD area. Maximum 4 areas you can set for FD function.
To enable the detection in Rule Switch.
Choose a Rule Type, only Normal available for this detection.
Use your mouse to click 4 points in the camera picture to draw a virtual region. The sharp of the region should be
a convex polygon. Concave polygon will be not able to save.
Click Save to save your settings.
If you want to adjust the size of the region, click the red box in the region, the borders of the region will be
changed to red color. Long press the left button of your mouse to move the whole region, or drag the corners to
resize the region.
If you want to remove one of the regions from the camera picture, click the red box in the region and then click
Remove button. Click Remove All will delete all regions.
Notice:
The region for detection shall not be in the area that people cannot reach.
o
The region should include the complete front face.
o
3.5.8.6
CC (Cross-Counting)
Cross-Counting function counts the times for moving objects or people across the virtual lines.
Channel: to select the channel you want to configure
•
Switch: to enable or disable the CC function
•
Buzzer: to disable or to active the buzzer to emit an alarm tone in 10, 20, 40 or 60 seconds when the detection is
•
triggered
Sensitive: The sensitivity level is from 1 to 4, with a default value of 2. Higher sensitivity will be easier to trigger
•
the detection.
Scene: Scene setting includes Indoor and Outdoor. Please choose the scene to match with the place your
•
camera installed.
Post Recording: You can set how long after an event occurs that the HVR will continue to record.
•
Latch Time: To configure the external alarm time when the detection is triggered.
•
Alarm Out: If your HVR support to connect to external alarm device, you can set to emit an alarm tone.
•
Show Message: A letter "S" will be displayed on the screen when the intelligent detection is triggered.
•
Send Email: If an alarm is triggered, an Email will be sent to your preset email account.
•
Full Screen: When the detection is triggered, the channel will be enlarged into full screen.
•
Record Channel: to select the channel(s) you want to record when a detection is triggered.
•
Area: Click [Setup] to draw a virtual region in the camera picture.
•
DS1097-010
42
Advertisement
Table of Contents
