Table 2-13: Warranted Characteristics - Output Ports - Tektronix TDS 700D Technical Reference

Table 2–12: Warranted characteristics — Triggering system (Cont.)
Name
Accuracy (Time) for Pulse-Glitch or
Pulse-Width Triggering P l e Wi Tri eri
Input Signal Sync Amplitude for Stable
Triggering, NTSC and PAL modes
(Option 05 Video Trigger)
Jitter (Option 05 Video Trigger)
1
The minimum sensitivity for obtaining a stable trigger. A stable trigger results in a uniform, regular display triggered on
the selected slope. The trigger point must not switch between opposite slopes on the waveform, and the display must not
"roll" across the screen on successive acquisitions. The TRIG'D LED stays constantly lighted when the SEC/DIV setting
is 2 ms or faster but may flash when the SEC/DIV setting is 10 ms or slower.
2
For Slew Rate Triggering, this is the minimum transition time, defined to be the time the user's signal spends between
the two trigger threshold settings.
Table 2–13: Warranted characteristics — Output ports, probe compensator, and power requirements
Name
Logic Levels, Main- and Delayed-Trigger
Outputs p
Output Voltage and Frequency,
Pr be mpe a r
Probe Compensator
Output Voltage, Signal Out (CH 3
Source Voltage
Source Frequency
Power Consumption
1
CH 3 signal out is present at the rear panel if CH 3 (AUX 1 on the TDS 620B or 680B) is selected as the trigger source for
the main and/or delayed trigger systems. It is not available when a channel other than CH3 (AUX 1 on the TDS 620B or
680B) is the source for the Video Trigger when Option 05 is installed.
TDS 500D, TDS 600B & TDS 700D Performance Verification and Specifications
Description
Time range
1 ns to 500 ns
500 ns to 1 s
Field selection "Odd", "Even", or "All": 0.6 division to 4 divisions
Field selection "Numeric": 1 division to 4 divisions (NTSC mode)
60 ns on NTSC or PAL signal
p-p
Description
Characteristic
Vout (HI)
Vout (LO)
Characteristic
Output Voltage
Frequency
1
) For TDS 600B: 20 mV/division 20% into a 1 M load;
10 mV/division 20% into a 50
For TDS 500D/700D:
22 mV/division 20% into a 1 M load;
11 mV/division 20% into a 50
100 to 240 VAC
RMS
45 Hz to 440 Hz
350 W (450 VA)
Accuracy
(20% of setting + 0.5 ns)
(100 ns + 0.01% of Setting)
Limits
load to ground
Limits
0.5 V (base-top) 1% into a 50
1 kHz 5%
, continuous range, CAT II
Warranted Characteristics
2.5 V open circuit; 1.0 V into a 50
0.7 V into a load of 4 mA;
0.25 V into a 50 load to ground
load
load
load
2–23