Table 1-2: Dc Offset Accuracy (Zero Setting) - Tektronix TDS 700D Technical Reference

Performance Tests
1–30
b. Set the vertical scale: Set the vertical SCALE to one of the settings
listed in Table 1–2 that is not yet checked. (Start with the first setting
listed).
Press VERTICAL MENU. Press the main-menu button Fine Scale.
Use the keypad to enter the vertical scale. For the 1 mV setting,
press 1, SHIFT, m, then ENTER. For the 101 mV setting, press
101, SHIFT, m, then ENTER. For the 1.01 V setting, press 1.01,
then ENTER.
Press CLEAR MENU.
Table 1–2: DC offset accuracy (zero setting)
Vertical
Vertical scale
position and
setting
offset setting
1 mV 0
101 mV 0
1.01 V 0
10 mV 0
101 mV 0
1
Vertical position is set to 0 divisions and vertical offset to 0 V when the
oscilloscope is initialized in step 1.
c. Display the test signal: The waveform position and offset were
initialized for all channels in step 1 and are displayed as you select each
channel and its vertical scale.
d. Measure the test signal: Align the active cursor over the waveform by
rotating the general purpose knob. Ignore the other cursor. See
Figure 1–4.
e. Read the measurement results at the absolute (@:) cursor readout, not
the delta ( :) readout on screen. That is, read the offset relative to the
ground reference. See Figure 1–4.
f. Check against limits: Do the following subparts in the order listed.
CHECK that the measurement results are within the limits listed for
the current vertical scale setting.
TDS 500D, TDS 600B & TDS 700D Performance Verification and Specifications
TDS 600B offset
1
accuracy limits
2.1 mV
75.6 mV
756 mV
TDS 794D offset accuracy limits
2.5 mV
25.1 mV
TDS 500D/700D
(except TDS 794D)
offset accuracy
limits
1.6 mV
25.1 mV
251 mV