Table 2-12: Warranted Characteristics - Triggering System; Table 2-13: Warranted Characteristics - Output Ports, Probe - Tektronix TDS 600B Performance Verification Manual

Warranted Characteristics
Table 2–12: Warranted characteristics — Triggering system
Name
Sensitivity, Edge-Type Trigger, Coupling
1 1
set to "DC" e
Accuracy (Time) for Pulse-Glitch or
Pulse-Width Triggering P l e Wi Tri eri
Input Signal Sync Amplitude for Stable
Triggering, NTSC and PAL modes
(Option 05 Video Trigger)
Jitter (Option 05 Video Trigger)
1
The minimum sensitivity for obtaining a stable trigger. A stable trigger results in a uniform, regular display triggered on
the selected slope. The trigger point must not switch between opposite slopes on the waveform, and the display must not
"roll" across the screen on successive acquisitions. The TRIG'D LED stays constantly lighted when the SEC/DIV setting
is 2 ms or faster but may flash when the SEC/DIV setting is 10 ms or slower.
Table 2–13: Warranted characteristics — Output ports, probe compensator, and power requirements
Name
Logic Levels, Main- and Delayed-Trigger
Outputs p
2–20
Description
Trigger source
Any Channel
Auxiliary
Time range
1 ns to 1 s
1.02 s to 1 s
Field selection "Odd", "Even", or "All": 0.6 division to 4 divisions
Field selection "Numeric": 1 division to 4 divisions (NTSC mode)
60 ns on NTSC or PAL signal
p-p
Description
Characteristic
Vout (HI)
Vout (LO)
TDS 500C, TDS 600B & TDS 700C Performance Verification and Specifications
Sensitivity
TDS 620B & 644B: 0.35 division from DC to 50 MHz, increasing to
1 division at 500 MHz
TDS 680B & 684B: 0.35 division from DC to 50 MHz, increasing to
1 division at 1 GHz MHz
TDS 500C, 724C, & 754C: 0.35 division from DC to 50 MHz,
increasing to 1 division at 500 MHz
TDS 784C: 0.35 division from DC to 50 MHz, increasing to
1 division at 1 GHz
TDS 600B: 250 mV from DC to 50 MHz, increasing to 500 mV at
100 MHz
TDS 500C, 724C, & 754C: 400 mV from DC to 50 MHz,
increasing to 750 mV at 100 MHz
TDS 784C: 250 mV from DC to 50 MHz, increasing to
500 mV at 100 MHz
Accuracy
(20% of setting + 0.5 ns)
(100 ns + 0.01% of Setting)
Limits
2.5 V open circuit; 1.0 V into a 50
load to ground
0.7 V into a load of 4 mA;
0.25 V into a 50 load to ground