Hood Sensor - HP xw9300 Service And Technical Reference Manual

Hood Sensor

To remove the hood sensor:
1. Disconnect power from the system
2. Unlatch the plastic snap that secures the cables inside the chassis.
3. Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front panel
harness.
4. Slide the hood sensor forward, push the hood sensor down, and remove it from the chassis.
CAUTION: Be careful when sliding the hood sensor forward. The hood sensor bracket and the chassis
contain sharp edges that present a safety hazard.
To replace the hood sensor, reverse the previous steps.
88 Removal and Replacement Procedures
(page 79) and remove the access panel (page 86).