HP xw9300 Service And Technical Reference Manual page 169

Table 5-38 POST Error Messages (continued)
Screen Message
1782—Disk Controller
Failure
1790—Disk 0 Error
1791—Disk 1 Error
1792—Secondary Disk
Controller Failure
1793—Secondary
Controller or Disk Failure
1794—Inaccessible devices
attached to primary IDE
controller
Probable Cause
Hard drive circuitry error.
The drive is not installed correctly or
has failed.
The drive is not installed correctly or
has failed.
Hard drive circuitry error.
Hard drive circuitry error.
Devices attached to the primary IDE
controller are inaccessible while the
SATA controller is set to "Replace
Primary IDE Controller" in Setup.
Recommended Action
1. Run Computer Setup (F10 Setup).
2. Clear CMOS.
3. Check cable seating/jumper settings.
4. Run hard drive diagnostics.
5. Disconnect additional drives.
6. Run the Drive Protection System test,
if available.
7. Replace the hard drive.
8. Replace the system board.
1. Make sure that any jumpers are set correctly,
and that power and drive cables are
connected, both to the drive and the system
board.
2. Verify that the cables are the correct cables
for your computer model.
If this message persists, you might need service
for your workstation.
1. Make sure that any jumpers are set correctly,
and that power and drive cables are
connected, both to the drive and the system
board.
2. Verify that the cables are the correct cables
for your computer model.
If this message persists, you might need service
for your workstation.
1. Run Computer Setup (F10 Setup).
2. Clear CMOS.
3. Check cable seating/jumper settings.
4. Run hard drive diagnostics.
5. Disconnect additional drives.
6. Run the Drive Protection System test,
if available.
7. Replace the hard drive.
1. Run Computer Setup (F10 Setup).
2. Clear CMOS.
3. Check cable seating/jumper settings.
4. Run hard drive diagnostics.
5. Disconnect additional drives.
6. Run the Drive Protection System test,
if available.
7. Replace the hard drive.
1. Run Computer Setup (F10 Setup).
2. Select Storage > Storage Options and
set SATA controller to Add as Separate
Controller.
Power On Self Test (POST) and Error Messages 169