HP xw9300 Service And Technical Reference Manual page 123

8. Rotate the CPU heatsink away
metal clamp and rotating the entire CPU heatsink assembly away from the processor retention frame.
9. When you have rotated the CPU heatsink assembly about 45 degrees, free the metal clamp
under the black tension lever then lift the CPU heatsink up and away from the system board.
10.Use alcohol and a soft cloth to clean all of the thermal interface material residue from the CPU heatsink
and processor.
CAUTION: Allow the alcohol on the processor and CPU heatsink to dry completely.
To replace the CPU heatsink:
1. Disconnect power from the system
CPU heatsink (page 116).
2. Use alcohol and a soft cloth to clean all of the thermal interface material residue from the CPU heatsink
and processor.
CAUTION: Allow the alcohol on the processor and CPU heatsink to dry completely.
Check for proper processor seating in the socket by carefully trying to lift the processor out of the
3.
socket with your fingers. A properly seated processor does not lift out of the socket.
4. Apply thermal grease to center of the processor. If using a new CPU heatsink, remove and discard the
thermal grease protective liner from the bottom of the new CPU heatsink.
NOTE: Do not touch the exposed thermal grease when handling the CPU heatsink.
1 from the system board by lifting the side where you released the
(page 79), remove the access panel (page 86), and remove the
Removal and Replacement of Components 123
2 that is