HP xw9300 Service And Technical Reference Manual page 167

Hp xw9300: reference guide
Hide thumbs Also See for xw9300:
Table of Contents

Advertisement

Table 5-38
POST Error Messages (continued)
Screen Message
304—Keyboard or System
Unit Error
501—Display Adapter
Failure
510—Splash Screen image
corrupted
511—CPU0 or CPU1 Fan
not detected
512—Chassis, rear chassis,
or front chassis fan not
detected
601—Diskette Controller
Error
605—Diskette Drive Type
Error
611—Primary Diskette Port
Address Assignment Conflict
912—Computer Cover Has
Been Removed Since Last
System Start Up
917—Front Audio Not
Connected
918—Front USB Not
Connected
Probable Cause
Keyboard failure.
Graphics display controller.
Splash Screen image has errors.
Fan is not connected or might have
malfunctioned.
Fan is not connected, might have
malfunctioned.
Diskette controller circuitry or
diskette drive circuitry incorrect.
Mismatch in drive type.
Configuration error.
Access panel has been removed.
The front audio cable is not
connected.
Front USB is not connected.
Recommended Action
1.
Reconnect the keyboard with workstation
turned off.
2.
Be sure that none of the keys are pressed.
3.
Replace keyboard.
4.
Replace system board.
1.
Reseat the graphics card (if applicable).
2.
If using PCI Express card with auxiliary power
cable, be sure it is attached.
3.
Clear CMOS.
4.
Verify that the monitor is attached and
turned on.
5.
Replace the graphics controller.
Install latest version of ROMPaq to restore image.
1.
Reseat fan cable.
2.
Reseat the fan.
3.
Replace the fan.
1.
Reseat chassis, rear chassis, or front chassis
fan cable.
2.
Reseat chassis, rear chassis, or front
chassis fan.
3.
Replace chassis, rear chassis, or front
chassis fan.
1.
Run Computer Setup (F10 Setup).
2.
Check and replace cables.
3.
Clear CMOS.
4.
Replace diskette drive.
5.
Replace the system board.
1.
Run Computer Setup (F10 Setup).
2.
Disconnect any other diskette controller
devices (tape drives).
3.
Clear CMOS.
1.
Run Computer Setup (F10 Setup).
2.
Remove expansion cards.
3.
Clear CMOS.
No action required.
Connect front audio cable.
Connect front USB cable.
Power On Self Test (POST) and Error Messages 167

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents