HP xw9300 Service And Technical Reference Manual page 112

4. Attach the rails to the hard drive by first inserting the hard drive rail assembly pins into one side of the
hard drive screw holes. Next, gently flex open the opposite side of the hard drive rail assembly and
insert the remaining pins into the holes in the hard drive. If installing the hard drive into bay 5, skip this
step.
5. Push the drive into the selected bay until it snaps into place. Then attach the power and SCSI cable to
the drive.
NOTE: If installing a hard drive into bay 5, lay the workstation on its side and remove the three drive
screws that are located near bay 5. Insert the drive into bay 5 and align the holes in the bottom of the
hard drive with the screw holes at the base of the chassis. Insert the screws through the base and tighten
the hard drive to the chassis.
112 Removal and Replacement Procedures