HP xw9300 Service And Technical Reference Manual page 100

To remove a PCI Express card:
1. Disconnect power from the system
card support
2. Lift the PCI levers
3. Remove the power supply cable
the card 4
4. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards are
properly seated and then try again.
To install a PCI Express card:
1. Disconnect power from the system
card support
2. Lift the PCI levers
3. Remove the PCI slot cover
4. Lower the PCI Express
the socket.
5. If required, plug in the power supply cable
6. Close the PCI levers
100 Removal and Replacement Procedures
(page
(page 98), if installed.
1 by first pressing down and then up.
2 , if installed, and press in on the "hockey stick" lever
out of the chassis. Store the card in an anti-static bag.
(page
(page 98), if installed.
1 by first pressing down and then up.
2 .
3 card into the chassis. Verify that the keyed components of the card align with
5 . If the PCI levers do not close, be sure all cards are properly seated.
79), remove the access panel
79), remove the access panel
4
.
(page 86) and remove the PCI
3 while lifting
(page 86) and remove the PCI