HP xw9300 Service And Technical Reference Manual page 52

Table 3-11 Computer Setup Menu Descriptions (continued)
Heading Option
Processors
Chipset/
Memory
Onboard
Devices
Device
Options
Thermal
PCI VGA
Configuration
Slot 1 (PCI
Express x 16)
Slot 2 (PCI)
Slot 3 (PCI
Express x 16)
Slot 4 (PCI-X
100)
Slot 5 (PCI-X
100)
52 System Management
Description
Enable/disable Processor Cache and Coherent HT Speed*.
NOTE: You can set the Hyper Transport Speed between the CPUs to one of the
following values: 200, 400, 600, 1000, and Auto.
*This option is only available on systems with two processors.
Enable/disable ECC support, Memory scrubbing, Memory remapping, and PCI SERR#
generation.
Enables you to set resources for or disable onboard system devices (serial ports, USB
ports, diskette controllers, and so on).
Allows you to enable/disable:
• SATA Option ROM
• SATA RAID
• When SATA RAID is enabled, the following items are displayed:
SATA PORT # to 0 RAID
You must enable the port before using RAID.
SATA PORT # to 1 RAID
You must enable the port before using RAID.
SATA PORT # to 2 RAID
You must enable the port before using RAID.
SATA PORT # to 3 RAID
You must enable the port before using RAID.
• SCSI Option ROM
• Network Controller Option
Enable/disable full speed chassis fans.
NVIDIA VGA controller*
Specifies if controller is Primary VGA device/Non-boot device.
NVIDIA VGA controller**
Specifies if controller is Primary VGA device/Non-boot device.
* This controller refers to slot 1.
**This controller refers to slot 3, which is only available in a system with two graphics
cards.
Configures the option ROM.
Configures the option ROM and latency timer.
Configures the option ROM.
Configures the option ROM and latency timer.
Configures the option ROM and latency timer.