HP xw9300 Service And Technical Reference Manual page 102

NOTE: The following illustration shows a PCI card being installed in a PCI slot. A PCI-X card must be
installed in a PCI-X slot.
To install a PCI or PCI-X card:
1. Disconnect power from the system
card support
2. Lift the PCI levers
3. Remove the PCI slot cover
4. Lower the PCI
socket.
5. Close the PCI levers
try again.
102 Removal and Replacement Procedures
(page
(page 98).
1 by first pressing down and then up.
2 .
3 card into the chassis. Verify that the keyed components of the card align with the
4 . If the PCI levers do not close, be sure all cards are properly seated and then
79), remove the access panel (page 86), and remove the PCI