HP xw4300 Installation Manual

Optical drive installation for hp workstations
Hide thumbs Also See for xw4300:

Advertisement

Available languages

Available languages

This document describes how to install an optical drive on an HP Workstation.

Electrostatic Discharge

A discharge of static electricity from a finger or other conductor may damage system boards or other
static-sensitive devices. This type of damage may reduce the life expectancy of the device.

Preventing Electrostatic Damage

To prevent electrostatic damage, observe the following precautions:
■ Avoid hand contact by transporting and storing parts in static-safe containers.
■ Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.
■ Place parts on a grounded surface before removing them from their container.
■ Avoid touching pins, leads, or circuitry.
■ Always be properly grounded when touching an electrostatic-sensitive component or assembly.

Grounding Methods

There are several methods for grounding. Use one or more of the following measures when handling or
installing electrostatic- sensitive parts:
■ Use a wrist strap connected by a ground cord to a grounded workstation chassis. Wrist straps are
flexible straps with a minimum of 1 meg. ohm +/- 10 percent resistance in the ground cords. To
provide a proper ground, wear the strap snug against the skin.
■ Use heelstraps, toestraps, or bootstraps at standing workstations. Wear the straps on both feet when
standing on conductive floors or dissipating floor mats.
■ Use conductive field service tools.
■ Use a portable field service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have an authorized dealer,
reseller, or service provider install the part.
NOTE: For additional information on static electricity or for assistance with the installation of this
product, contact an authorized dealer, reseller, or service provider.
Optical Drive Installation
for HP Workstations
1

Advertisement

Table of Contents
loading

Summary of Contents for HP xw4300

  • Page 1: Electrostatic Discharge

    Optical Drive Installation This document describes how to install an optical drive on an HP Workstation. Electrostatic Discharge A discharge of static electricity from a finger or other conductor may damage system boards or other static-sensitive devices. This type of damage may reduce the life expectancy of the device.
  • Page 2: Preparing For Installation

    HP-supplied metric screws are black. On other workstations, the optical drives do not require these guide screws. Instead, the drive cage is equipped with a latching mechanism to secure the optical drive in place.
  • Page 3: Preparing The Workstation

    ■ Avoid exposing the drive to sudden changes in temperature, as condensation may form inside the unit. If the temperature suddenly changes while the drive is on, wait at least one hour before you turn off the power. If you operate the unit immediately, it may malfunction while reading. ■...
  • Page 4: Installing The Drive

    Installing the Drive NOTE: Your workstation may not be identical to the workstation in the following illustrations.If you need more information, refer to the documentation included with the workstation for drive installation procedures. NOTE: In some workstations, there may be drive length limitations for some of the drive bays. 1.
  • Page 5 5. Install two M3 black guide screws into each side of the drive. NOTE: Some workstations, such as the xw6200 and xw8200, do not require these guide screws. 6. Slide the optical drive completely into a drive bay so that the drive is secured. On some workstation models, you will need to lift the spring-loaded latch on the left side of the optical drive cage while sliding the new drive in.
  • Page 6 7. Connect the power, drive, and audio (if required) cables to the drive and workstation. NOTE: Linux systems require the installation of the audio cable (see the illustration below). The location of the connector varies depending on your system. Refer to the documentation CD that shipped with your system for the appropriate location.
  • Page 7: Operating The Drive

    Operating the Drive Identifying the Controls Item Components Drive Activity Light Manual Eject Button Disc Tray Load/Unload Button NOTE: The drive bezel and drive controls may not be identical to those shown. Opening the Tray Manually If you have exited the CD application and are unable to eject the disc with the load/unload button or if right-clicking on the drive letter and selecting the eject function does not work, you can eject the disc manually.
  • Page 8: Regulatory Notices

    Device 1 connector (secondary drive) System board connector © 2004 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. Microsoft and Windows are U.S. registered trademarks of Microsoft Corporation. Linux is a U.S. registered trademark of Linus...
  • Page 9 オプ テ ィ カル ド ラ イ ブのイ ン ス ト ール 本書では、 HP ワー ク ス テーシ ョ ンにオプテ ィ カル ド ラ イ ブ を イ ン ス ト ールす る 方法を説明 し ます。 静電気対策 人間の指な ど、 導電体か ら の静電気の放電に よ っ て、 シ ス テ ム ボー ド な ど静電気に弱いデバ イ...
  • Page 10 付属 し てお り 、 フ ロ ン ト ベゼルの下のシ ャ ーシの前面、 も し く は、 ア ク セ ス パネルの下のデ ィ ス ケ ッ ト ド ラ イ ブ ブ ラ ケ ッ ト にあ り ます。 HP が提供す る メ ー ト ル式ネジの色は黒です。...
  • Page 11 キ ャ ビ ネ ッ ト の中に異物や液体が入っ て し ま っ た場合は、 直ちに ワー ク ス テーシ ョ ン の電 源を切 り 、 電源 コ ー ド を AC コ ン セ ン ト か ら 抜いて、 HP のサポー ト 窓口に点検を依頼 し て...
  • Page 12 ド ラ イ ブの取 り 付け 注記 : お使いの ワー ク ス テーシ ョ ンの外観は、 以下の図 と 多少異な る 場合があ り ます。 ド ラ イ ブの取 り 付 けについて詳 し く は、 お使いの ワー ク ス テーシ ョ ンに付属の ド キ ュ メ ン ト を参照 し て く だ さ い。 注記...
  • Page 13 5. ド ラ イ ブの両側に黒の M3 ガ イ ド 用ネジ を 2 本ずつ取 り 付け ます。 注記 : xw6200 や xw8200 な ど の ワ ー ク ス テーシ ョ ンには、 こ れ ら のガ イ ド 用ネジは必要あ り ません。 6.
  • Page 14 7. 電源ケーブル、 ド ラ イ ブ ケーブル、 お よ び、 オーデ ィ オ ケーブル (必要な場合) を、 ド ラ イ ブ と ワ ー ク ス テーシ ョ ンに接続 し ます。 注記 : Linux シ ス テ ムには、 オーデ ィ オ ケーブル (以下の図を参照) を イ ン ス ト ールす る 必要があ り ます。 コ...
  • Page 15 4. 該当す る CD-ROM ド ラ イ ブ を右 ク リ ッ ク し て、 [ プ ロパテ ィ ] を ク リ ッ ク し ます。 5. [ プ ロパテ ィ ] タ ブ を ク リ ッ ク し て、 [ こ の CD-ROM デバ イ ス でデジ タ ル音楽 CD を使用可 能にす...
  • Page 16 オプ テ ィ カル ド ラ イ ブの使い方 各部の名称 項目 ド ラ イ ブ ラ ン プ 手動取 り 出 し ホール CD ト レ イ 開閉ボ タ ン 注記 : お使いのオプテ ィ カル ド ラ イ ブの ド ラ イ ブ ベゼルや ド ラ イ ブの各部は、 図 と 多少異な る 場合があ り...
  • Page 17 デバイ ス 1 用 コ ネ ク タ (セ カ ン ダ リ ド ラ イ ブ用) シ ス テム ボー ド 用 コ ネ ク タ © 2004 Hewlett-Packard Development Company, L.P. The HP Invent logo is a registered trademark of Hewlett-Packard Development Company, L.P. Microsoft お よ び Windows は、 米...

Table of Contents