Access Panel
Before accessing the internal components of the workstation, the access panel must be removed.
To remove the access panel:
WARNING!
that the power cord is disconnected from the electrical outlet.
1.
Disconnect power from the system
If necessary, unlock the access panel
2.
1
3.
Pull up
To replace the access panel, slide the cover back on until it snaps into place.
86
Removal and Replacement Procedures
Before removing the workstation access panel, be sure that the workstation is turned off and
(page
on the handle and lift off
79) and lay the workstation on its side as shown.
(page
84). The keys are on the rear panel.
2
the cover.