Table of Contents
Advertisement
2 • Stacker Setup and Operation
Tandem Belt Stacker
There is a configuration of the stacker for Relay inserters that enables
the automatic stacking of letters and flats simultaneously. This stacker
configuration consists of two stacker units mounted onto one set of legs
or one table at the correct vertical spacing to receive letter and flats'
output from the inserter.
•
Use the letters in-line instructions included here to set up and operate
the top stacker unit and the flats in-line instructions for the lower
stacker unit.
Use the Belt Stacker with Other Equipment
The belt stacker can be used with equipment other than inserters (for
example, address printers).
Depending on the equipment being used and the material being run,
either a right-angled or in-line configuration are used.
You will receive full details of your particular setup at the time installation.
2-14
SV40231 Rev. C
Advertisement
Table of Contents
