Mitsubishi Electric MELSERVO-J2 Series Instruction Manual page 186

8. COMMUNICATION FUNCTIONS
(11) Dwell time write
Write the dwell time of the point table.
Transmit command [C][A], any of data No. [0][1] to [0][F] corresponding to the point table to be
written to, and the data. Refer to Section 8.11.2.
Command
[C][A]
0
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the dwell time constant is changed frequently through communication,
set "1" to the write mode to change only the RAM data in the servo amplifier.
When changing data frequently (once or more within one hour),
do not write it to the EEP-ROM.
(12) Auxiliary function write
Write the auxiliary function of the point table.
Transmit command [C][B], any of data No. [0][1] to [0][F] corresponding to the point table to be
written to, and the data. Refer to Section 8.11.2.
Command
[C][B]
0
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the auxiliary function constant is changed frequently through communication,
set "1" to the write mode to change only the RAM data in the servo amplifier.
When changing data frequently (once or more within one hour),
do not write it to the EEP-ROM.
Downloaded from ManualsNet.com
Data No. Data
[0][1] to
See below.
[0][F]
Hexadecimal data
Data No. Data
[0][1] to
See below.
[0][F]
Hexadecimal data
search engine
8 - 31