6. SERVO CONFIGURATION SOFTWARE
6.7.5 Single-step feed
Operation is performed in accordance with the preset point table No.
Click "Test" on the menu bar and click "Single-step Feed" on the menu.
When the above choices are made, the following window appears:
a)
(1) Point table No. setting ( a) )
Enter the point table No. into the "Point table No." input field and press the enter key.
(2) Servo motor start ( b) )
Click the "Start" button to rotate the servo motor.
(3) Temporary stop of servo motor ( c) )
Press the "Pause" button to stop the servo motor temporarily.
Click the "Start" button to resume rotation.
(4) Servo motor stop ( d) )
Click the "Pause" button again during a temporary stop of the servo motor to clear the remaining
moving distance.
(5) Single-step feed window closing ( e) )
Click the "Close" button to cancel the single-step feed mode and close the window.
Downloaded from
ManualsNet.com
search engine
6 - 16
b)
c)
d)