HP Visualize b132L Service Handbook page 154

Field Replaceable Units
FRU Removal and Replacement
2
NOTICE: When replacing the EGRAM module make sure
that its connector is correctly aligned with the
connector on the CPU board and press down firmly
to make sure that it is fully connected. Press down
on the corners of the module to make sure that the
standoffs are fully engaged.
If you are moving the EGRAM module to a new
CPU board assembly, from the underside of the
CPU board assembly use a pair of needle-nose
pliers to squeeze the tabs on the standoffs and push
them out of the CPU board. Transfer the standoffs
to the new CPU board.
132
Grasp the EGRAM module from the sides and pull
it straight up to disconnect it from the CPU board
connector
, as shown in Figure 41.