HP Visualize b132L Service Handbook page 214

Boot Console Interface
Displaying and Setting Paths
To set a system path to a new value, follow the direc-
tions in "Accessing the Boot Console Interface" ear-
lier in this chapter, and then type the following at the
prompt:
Main Menu: Enter command>
where path_type is one of the path types listed in Table
38 and path is the specification of the path in Mne-
monic Style Notation (as described in Table 39).For
example, to set the primary boot path to a scsi disk
with an ID of 6.0, follow the directions in "Accessing
the Boot Console Interface" earlier in this appendix,
and then type the following at the prompt:
Main Menu: Enter command>
192
path path_type path
path pri sescsi.6.0