BMW Motorrad R 1250 R Rider's Manual page 95

Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
with Keyless Ride
Switch off the ignition.
Press button 1 on the radio-
operated key twice.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
To deactivate the motion
sensor (for example if you are
about to transport the motor-
cycle on a train and the sway-
ing movement of the mov-
ing train could trip the alarm),
OE
press button 1 on the radio-
operated key again during the
activation phase.
Turn indicators flash three
times.
Confirmation tone sounds
three times (if programmed).
Motion sensor has been
deactivated.
Alarm signal
A DWA alarm can be triggered
by:
Motion sensor
Switch-on attempt with an
unauthorised vehicle key.
Disconnection of the DWA
anti-theft alarm from the
motorcycle's battery (DWA
internal battery in the anti-
theft alarm provides power -
acoustic alarm only, the turn
indicators do not flash)
with Keyless Ride
When the radio-oper-
ated key is within range,
an alarm triggered by the tilt
sensor is suppressed.
All functions are sustained even
if the internal battery of the
DWA anti-theft alarm system is
flat; the only difference is that
an alarm cannot be triggered
if the system is disconnected
from the motorcycle's battery.
89
OE