BMW Motorrad R 1250 R Rider's Manual page 201

Install screw 1.
Replacing LED rear light
The LED rear light can be re-
placed only as a complete unit.
Consult a specialist work-
shop, preferably an authorised
BMW Motorrad dealer.
Replacing LED turn indicators
with LED flashing turn indic-
ator OE
LED turn indicators can be re-
placed only as a complete unit.
Consult a specialist work-
shop, preferably an authorised
BMW Motorrad dealer.
Replacing LED side light
The LED side light can be
replaced only as a complete
unit. Consult a specialist
workshop, preferably an
authorised BMW Motorrad
retailer.
Replacing bulbs for low-beam
and high-beam headlight
The arrangements of the
connectors and the light
sources may differ from the
following figures.
The procedure described
here for replacing the low-
beam headlight bulb applies
by analogy for the high-beam
headlight bulb.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
with Sport windscreen
Remove screws 1. Make sure
that the shouldered bushings
from the grommets are not
mislaid.
Remove windscreen 2.
195
OE