Table of Contents
Advertisement
ETC Installation Guide
0–10 V Dimming Switch Sensor
Installation
1. Before you begin:
Read and follow all
•
understand the
•
mounting,
and ensure that the installation
•
2. Install a standard NEMA wall box and pull all required line voltage,
0-10 V dimming, and load wires to the installed box according to your
installation requirements. See
3.
The sensor wires are pre-stripped for convenience.
Prepare the installed wires and secure each
connection type (line, dim+, dim-, load, ground, and
neutral) with a suitable wire nut (not provided).
4. Dress the wires neatly into the wall box, and then
attach the sensor to the box using the screws
provided.
5. If you need to change the sensor settings, gently depress the push-
button cover and slide it down to reveal the configuration switches.
6. See the instructions in
and commissioning.
Note:
commissioning purposes.
0–10 V Dimming Switch Sensor
Safety
Specifications
Power Up
By factory default, light sensing is disabled for testing and
requirements,
for electrical, environment, and
Location
meets the requirements.
Electrical
for wiring topology.
and
Test
to complete the installation
Page 6 of 12
ON
Press
1 2
LUX
TIME
and
slide
ETC
Advertisement
Table of Contents
