Table of Contents
Advertisement
ETC Installation Guide
0–10 V Dimming Switch Sensor
Operation
The sensor uses dual technology sensors to detect occupancy and vacancy
status within its 180° field of view and features a 0–10 V dimming output to
manually control the lighting level. The sensor is configured as an occupancy
sensor by default, turning on the lighting load to 100% (default set
level) when occupancy is detected, and dimming the load to 33% of its set
level for 30 seconds when vacancy is detected (after the delay time expires),
after which the sensor will turn off the load. Customize the operation using
the onboard
When PIR detection is sensed, the button LED indicates in blue. When HFD
detection is sensed, the button LED indicates in green. Pressing either push
button changes the sensor's state manually according to the settings.
Pressing and holding the left button lowers the light level, and pressing and
holding the right button raises the light level. See
page 11
.
0–10 V Dimming Switch Sensor
DIP Switch Settings
.
Page 7 of 12
Use the Buttons on
ETC
Advertisement
Table of Contents
