Table of Contents
Advertisement
Installation Instructions
Choose a mounting method.
1. The axillary mounting plate allows mounting with the integrated
magnets to a steel T-bar ceiling frame or other metallic surface by
placing the sensor on the metal rail.
2. With screws and anchors (not provided) to a wall-board ceiling.
i. Use a pencil to mark the mounting base screw hole locations (sensor
unattached).
ii. Using a drill, bore the two holes and insert the anchors.
iii. Install the mounting plate adapter to the ceiling with the screws.
iv. Place the sensor so the keyholes are over the pegs on the mounting
plate adapter and slide the sensor sideways to align the sensor
and mounting plate.
3. With the provided wire straps to a soft ceiling tile.
i. Mark the sensor mounting location on the ceiling tile with a pencil.
Remove the ceiling tile from the T-bar frame.
ii. Insert the soft ceiling tile adapters through the pair of small holes
beside both keyholes on the sensors mounting plate.
iii. Poke the tines through the ceiling tile, then bend each tine over in
opposite directions for a secure fit.
iv. Replace the ceiling tile and attach the sensor to the mounting plate.
4. With double sided tape or Velcro™, not provided. Cut two lengths of
tape and remove the backing. Place on the mounting surface of the
sensors back plate, pressing down. Remove the backing from the
tape's other side and place the sensor on the ceiling surface, pressing
firmly.
Lens Masking
Lens mask stickers are provided in the packaging for your convenience to
block areas (such as a door way to a hall ie.)
1. As needed, peel off the lens masks to fit the desired area to be blocked.
2. Apply the mask gently to the section of the lens exterior to block the
required area from occupancy sensing.
Linking the Sensor to a Receiver
The MOS-MT must be linked with a receiver, via the steps below if using the
default VLD standard EnOcean EEP of D2-14-52
1. Activate LEARN or LINK mode at the receiver, if necessary refer to the
manufacturers documentation.
2. Press the MOS-MT's teach button.
3. Deactivate LEARN mode at the receiver.
If you require General Purpose telegrams, see the EEP select mode section in
4
.
Advertisement
Table of Contents
