Prepare For Installation - ETC Echoflex Elaho Installation Manual

Echoflex Installation Guide
Dual Tech Occupancy Sensor

Prepare for Installation

Ceiling-mount sensors are intended for installation to a finished ceiling
surface, soft ceiling tile mounted, or attached to a round or octagonal fixture
junction box.
Compliance
cULus Listed
•
CE compliant
•
For use with Echoflex Elaho Control Systems, powered by an Elaho station
power supply.
Environment
Ambient
For indoor, commercial controls use only. Operating temperature 0-40°C
(32-104°F), humidity maximum 90% (non-condensing).
Location
Echoflex recommends paying special attention to the installation
environment:
When operating in PIR only modes, the sensor must have an
•
unobstructed view of the room. Do not mount behind or near tall
cabinets, shelves, hanging light fixtures, etc.
Do not install the sensor within eight feet from an HVAC airflow
•
duct/vent.
Install the sensor where it cannot easily sense movement in areas
•
outside of the intended space, such as hallways, glass partitions, or
adjacent rooms. If the installation location cannot avoid these
conditions, portions of the lens can be masked to block the sensor
view of these undesired areas. See
Note:
may allow for better occupancy and vacancy detection results. See
Switches on page
Dual Tech Occupancy Sensor
In areas of increased noise activity, enabling PIR only mode
7.
Lens Masking on page 11
Page 2 of 12
.
DIP
Echoflex