Table of Contents
Advertisement
ETC Installation Guide
0–10 V Dimming Switch Sensor
Modes
Vacancy Sensing Only
The sensor in this mode requires an occupant to press the push button to
turn on the lighting load. When vacancy is detected, the sensor will dim the
lighting load to 33% of the set level for 30 seconds before turning off the
lights.
The sensor will automatically turn on the lighting load again if occupancy is
detected within 30 seconds after the time delay elapses.
Presentation Mode
In Presentation Mode, pressing the button turns off the connected lighting
load immediately and will ignore any occupancy detection. Pressing the
button again turns on the lighting load and the sensor resumes normal
operation according to its configured settings. If occupancy is not detected
before the time delay elapses, the sensor will resume its normal control and
turn on the lighting load again with the next occupancy event.
On/Off Button Control
When the sensor is set as an occupancy sensor (DIP switch 4 On), and the
push-button control function is set to On/Off control (DIP switch 5 On),
pressing either push button turns off the lighting load.
0–10 V Dimming Switch Sensor
Page 9 of 12
ETC
Advertisement
Table of Contents
