Renishaw RMP60 Installation Manual page 55

3
NOTES:
After removing the old batteries, wait more than 5 seconds before inserting the new batteries.
Do not mix new and used batteries or battery types, as this will result in reduced life and damage to
the batteries.
Always ensure that the cassette gasket and mating surfaces are clean and free from dirt before
reassembly.
If dead batteries are inadvertently inserted, the LEDs will remain a constant red.
Alkaline Lithium-thionyl chloride
× 2
AA 1.5 V AA 3.6 V Saft:

Tadiran:
Xeno:
NOTE: Lithium-thionyl chloride batteries are available from other manufacturers. However, these are
untested by Renishaw so correct operation of the probe cannot be guaranteed.
4
Battery types
× 2
LS 14500

SL-760/S,
TL-5903/S,
TL-2100/S
XL-060F
5
Nickel Cadmium / Nickel Metal Hydride
× 2
AA 1.2 V

5.3